AudioCodes Mediant 2000 User Manual

Version 6.6 653 Mediant 2000
User's Manual 45. Configuration Parameters Reference
45.11.9 Tone Parameters
This subsection describes the device's tone parameters.
45.11.9.1 Telephony Tone Parameters
The telephony tone parameters are described in the table below.
Tone Parameters
Parameter Description
[PlayHeldToneForIP2IP]
Enables playing a held tone to an IP-to-IP leg instead of placing it
on hold.
 [0] = (Default) Disabled. The device interworks the re-INVITE
with 'a=inactive' from one SIP leg to another SIP leg.
 [1] = Enabled. The device plays a held tone to the IP if it
receives a re-INVITE with 'a=inactive' in the SDP from the
party initiating the call hold. The held tone must be configured
in the CPT or PRT file.
Note: This parameter is applicable only to the IP-to-IP application.
Web/EMS: Dial Tone Duration
[sec]
[TimeForDialTone]
Defines the duration (in seconds) that the dial tone is played to an
ISDN terminal.
This parameter is applicable for overlap dialing when
ISDNInCallsBehavior is set to 65536. The dial tone is played if the
ISDN Setup message doesn't include the called number.
The valid range is 0 to 60. The default is 5.
Web/EMS: Reorder Tone
Duration [sec]
[TimeForReorderTone]
Defines the duration (in seconds) that the CAS device plays a
busy or reorder tone before releasing the line.
The valid range is 0 to 15. The default is 10 seconds. Note that
the Web interface denotes the default value as a string value of
"255".
Notes:
 The selected busy or reorder tone is according to the SIP
release cause code received from IP.
 This parameter is also applicable for ISDN when the
PlayBusyTone2ISDN parameter is set to 2.
 This parameter can also be configured in a Tel Profile.
Web: Cut Through Reorder
Tone Duration [sec]
[CutThroughTimeForReOrde
rTone]
Defines the duration (in seconds) of the reorder tone played to the
PSTN side after the IP call party releases the call, for the Cut-
Through feature. After the tone stops playing, an incoming call is
immediately answered if the PSTN is connected.
The valid values are 0 to 30. The default is 0 (i.e., no reorder tone
is played).
Note: To enable the Cut-Through feature, use the
DigitalCutThrough (for CAS channels) parameter.
Web: Play Busy Tone to Tel
[PlayBusyTone2ISDN]
Enables the device to play a busy or reorder tone to the PSTN
after a Tel-to-IP call is released.
 [0] Don't Play = (Default) Immediately sends an ISDN
Disconnect message.
 [1] Play when Disconnecting = Sends an ISDN Disconnect
message with PI = 8 and plays a busy or reorder tone to the

AudioCodes Mediant 2000 Specifications

General

Brand	AudioCodes
Model	Mediant 2000
Category	Gateway
Language	English