Version 6.6 229 Mediant 2000
User's Manual 18. Coders and Profiles
18 Coders and Profiles
This section describes configuration of the coders and SIP profiles parameters.
18.1 Configuring Coders
The Coders page allows you to configure up to 10 voice coders for the device. Each coder
can be configured with packetization time (ptime), bit rate, payload type, and silence
suppression. The first coder configured in the table has the highest priority and is used by
the device whenever possible. If the remote side cannot use the first coder, the device
attempts to use the next coder in the table, and so on.
Notes:
• A specific coder can only be configured once in the table.
• If packetization time and/or rate are not specified, the default is applied.
• Only the packetization time of the first coder in the coder list is declared in
INVITE/200 OK SDP, even if multiple coders are defined.
• The device always uses the packetization time requested by the remote side for
sending RTP packets. If not specified, the packetization time is assigned the
default value.
• The value of several fields is hard-coded according to common standards (e.g.,
payload type of G.711 U-law is always 0). Other values can be set dynamically. If
no value is specified for a dynamic field, a default is assigned. If a value is
specified for a hard-coded field, the value is ignored.
• If silence suppression is not configured for a coder, the settings of the
EnableSilenceCompression parameter is used.
• Both GSM-FR and MS-GSM coders use Payload Type 3. When using SDP, it isn’t
possible to differentiate between the two. Therefore, it is recommended not to
select both coders simultaneously.
• For G.729, it's also possible to select silence suppression without adaptations.
• If G.729 is selected and silence suppression is disabled, the device includes
'annexb=no' in the SDP of the relevant SIP messages. If silence suppression is
enabled or set to 'Enable w/o Adaptations', 'annexb=yes' is included. An exception
to this logic is when the remote gateway is a Cisco device (IsCiscoSCEMode).
• For defining groups of coders, which can be assigned to Tel and IP Profiles, see
'Configuring Coder Groups' on page 232.
• For information on V.152 and implementation of T.38 and VBD coders, see
'Supporting V.152 Implementation' on page 164.
• The Coders table can also be configured using the table ini file parameter,
CodersGroup.
To Next Page
Loading...
Need help?
General
