AudioCodes Mediant 2000 User Manual

Version 6.6 601 Mediant 2000
User's Manual 45. Configuration Parameters Reference
Parameter Description
Notes:
 For this parameter to take effect, a device reset is required.
 The called number can include several 'p' characters (1.5 seconds
pause), for example, 1001pp699, 8888p9p300.
Web: Enable Digit
Delivery to Tel
EMS: Enable Digit
Delivery
[EnableDigitDelivery]
Enables the Digit Delivery feature, which sends DTMF digits of the
called number to the device's B-channel (phone line) after the call is
answered for IP-to-Tel calls.
 [0] Disable (default).
 [1] Enable = Enable Digit Delivery feature for the device (two-
stage dialing).
If the called number in IP-to-Tel call includes the characters 'w' or 'p',
the device places a call with the first part of the called number (before
'w' or 'p') and plays DTMF digits after the call is answered. If the
character 'w' is used, the device waits for detection of a dial tone
before it starts playing DTMF digits. For example, if the called number
is '1007766p100', the device places a call with 1007766 as the
destination number, then after the call is answered it waits 1.5
seconds ('p') and plays the rest of the number (100) as DTMF digits.
Additional examples: 1664wpp102, 66644ppp503, and
7774w100pp200.
Notes:
 For this parameter to take effect, a device reset is required.
 This parameter can also be configured in a Tel Profile.
Web: Special Digit
Representation
EMS: Use Digit For
Special DTMF
[UseDigitForSpecialDTM
F]
Defines the representation for ‘special’ digits (‘*’ and ‘#’) that are used
for out-of-band DTMF signaling (using SIP INFO/NOTIFY).
 [0] Special = (Default) Uses the strings ‘*’ and ‘#’.
 [1] Numeric = Uses the numerical values 10 and 11.
45.11.3 Digit Collection and Dial Plan Parameters
The digit collection and dial plan parameters are described in the table below.
Digit Collection and Dial Plan Parameters
Parameter Description
Web/EMS: Dial Plan Index
[DialPlanIndex]
Defines the Dial Plan index to use in the external Dial Plan file. The
Dial Plan file is loaded to the device as a .dat file (converted using
the DConvert utility). The Dial Plan index can be defined globally or
per Tel Profile.
The valid value range is 0 to 7, where 0 denotes PLAN1, 1 denotes
PLAN2, and so on. The default is -1, indicating that no Dial Plan

AudioCodes Mediant 2000 Specifications

General

Brand	AudioCodes
Model	Mediant 2000
Category	Gateway
Language	English