Version 6.6 541 Mediant 2000
User's Manual 45. Configuration Parameters Reference
Parameter Description
[MaxRADIUSSessions]
Defines the number of concurrent calls that can communicate with the
RADIUS server (optional).
The valid range is 0 to 240. The default is 240.
EMS: RADIUS Auth
Number of Retries
[RADIUSRetransmission
]
Defines the number of retransmission retries.
The valid range is 1 to 10. The default is 3.
[RadiusTO]
Defines the time interval (measured in seconds) that the device waits
for a response before a RADIUS retransmission is issued.
The valid range is 1 to 30. The default is 10.
45.6 SIP Media Realm Parameters
The Media Realm parameters are described in the table below.
Media Realm Parameters
Parameter Description
Media Realm Table
Web: Media Realm Table
EMS: VoIP > Media >
Media Realm
[CpMediaRealm]
This table parameter defines the Media Realm table. The Media Realm
table allows you to divide a Media-type interface (defined in the Multiple
Interface table) into several realms, where each realm is specified by a
UDP port range.
The format of this parameter is as follows:
[CpMediaRealm]
FORMAT CpMediaRealm_Index = CpMediaRealm_MediaRealmName,
CpMediaRealm_IPv4IF, CpMediaRealm_IPv6IF,
CpMediaRealm_PortRangeStart, CpMediaRealm_MediaSessionLeg,
CpMediaRealm_PortRangeEnd, CpMediaRealm_TransRateRatio,
CpMediaRealm_IsDefault;
[\CpMediaRealm]
For example,
CpMediaRealm 1 = Mrealm1, Voice, , 6600, 20, 6790, , 1;
CpMediaRealm 2 = Mrealm2, Voice, , 6800, 10, 6890; , 0;
Notes:
ï‚§ For this parameter to take effect, a device reset is required.
ï‚§ For a detailed description of this table, see 'Configuring Media
Realms' on page 177.
Bandwidth Management per Media Realm Table
Web: Bandwidth
Management
[BWManagement]
This table parameter defines bandwidth management rules per Media
Realm.
The format of this parameter is as follows:
[ BWManagement ]
FORMAT BWManagement_Index =
BWManagement_MediaRealmIndex, BWManagement_ThresholdIndex,
BWManagement_RuleAction, BWManagement_Threshold,
BWManagement_Hysteresis;