Version 6.6 693 Mediant 2000
User's Manual 45. Configuration Parameters Reference
45.17 Automatic Update Parameters
The automatic update of software and configuration files parameters are described in the
table below.
Automatic Update of Software and Configuration Files Parameters
Parameter Description
General Automatic Update Parameters
[AutoUpdateCmpFile]
Enables the Automatic Update mechanism for the cmp file.
 [0] = (Default) The Automatic Update mechanism doesn't apply to
the cmp file.
 [1] = The Automatic Update mechanism includes the cmp file.
Note: For this parameter to take effect, a device reset is required.
[AutoUpdateFrequency
]
Defines the number of minutes that the device waits between automatic
updates. The default is 0 (i.e., the update at fixed intervals mechanism
is disabled).
Note: For this parameter to take effect, a device reset is required.
[AutoUpdatePredefined
Time]
Defines schedules (time of day) for automatic updates. The format of
this parameter is: 'HH:MM', where HH denotes the hour and MM the
minutes, for example, 20:18.
Notes:
 For this parameter to take effect, a device reset is required.
 The actual update time is randomized by five minutes to reduce the
load on the Web servers.
EMS: AUPD Verify
Certificates
[AUPDVerifyCertificate
s]
Determines whether the Automatic Update mechanism verifies server
certificates when using HTTPS.
 [0] = Disable (default)
 [1] = Enable
[AUPDCheckIfIniChang
ed]
Determines whether the Automatic Update mechanism performs CRC
checking to determine if the ini file has changed prior to processing.
 [0] = (Default) Do not check CRC. The ini file is loaded whenever the
server provides it.
 [1] = Check CRC for the entire file. Any change, including line order,
causes the ini file to be re-processed.
 [2] = Check CRC for individual lines. Use this option when the HTTP
server scrambles the order of lines in the provided ini file.
[ResetNow]
Invokes an immediate device reset. This option can be used to activate
offline (i.e., not on-the-fly) parameters that are loaded using the
parameter IniFileUrl.
 [0] = (Default) The immediate restart mechanism is disabled.
 [1] = The device immediately resets after an ini file with this
parameter set to 1 is loaded.
Software/Configuration File URL Path for Automatic Update Parameters
[CmpFileURL]
Defines the name of the cmp file and the path to the server (IP address
or FQDN) from where the device can load the cmp file and update itself.
The cmp file can be loaded using HTTP/HTTPS, FTP, FTPS, or NFS.
For example: http://192.168.0.1/filename
To Next Page
Loading...
Need help?
General
