Version 6.6 537 Mediant 2000
User's Manual 45. Configuration Parameters Reference
Parameter Description
IPsecProposalTable_DHGroup;
[ \IPsecProposalTable ]
For example:
IPsecProposalTable 0 = 3, 2, 1;
IPsecProposalTable 1 = 2, 2, 1;
In the example above, two proposals are defined:
ï‚§ Proposal 0: AES, SHA1, DH group 2
ï‚§ Proposal 1: 3DES, SHA1, DH group 2
Note: For a detailed description of this table, see 'Configuring IP Security
Proposal Table' on page 137.
45.4.7 OCSP Parameters
The Online Certificate Status Protocol (OCSP) parameters are described in the table
below.
OCSP Parameters
Parameter Description
Web: Enable OCSP
Server
EMS: OCSP Enable
[OCSPEnable]
Enables or disables certificate checking using OCSP.
ï‚§ [0] Disable (default)
ï‚§ [1] Enable
Web: Primary Server IP
EMS: OCSP Server IP
[OCSPServerIP]
Defines the IP address of the OCSP server.
The default IP address is 0.0.0.0.
Web: Secondary Server
IP
[OCSPSecondaryServe
rIP]
Defines the IP address (in dotted-decimal notation) of the secondary
OCSP server (optional).
The default IP address is 0.0.0.0.
Web: Server Port
EMS: OCSP Server Port
[OCSPServerPort]
Defines the OCSP server's TCP port number.
The default port number is 2560.
Web: Default Response
When Server
Unreachable
EMS: OCSP Default
Response
[OCSPDefaultRespons
e]
Determines the default OCSP behavior when the server cannot be
contacted.
ï‚§ [0] Reject = (Default) Rejects peer certificate.
ï‚§ [1] Allow = Allows peer certificate.