AudioCodes Mediant 2000

Version 6.6 503 Mediant 2000
User's Manual 45. Configuration Parameters Reference
45 Configuration Parameters Reference
The device's configuration parameters, default values, and their descriptions are
documented in this section.
Note: Parameters and values enclosed in square brackets [...] represent the ini file
parameters and their enumeration values.
45.1 Networking Parameters
This subsection describes the device's networking parameters.
45.1.1 Ethernet Parameters
The Ethernet parameters are described in the table below.
Ethernet Parameters
Parameter Description
EMS: Physical
Configuration
[EthernetPhyConfigurati
on]
Defines the Ethernet connection mode type.
 [0] = 10Base-T half-duplex
 [1] = 10Base-T full-duplex
 [2] = 100Base-TX half-duplex
 [3] = 100Base-TX full-duplex
 [4] = (Default) Auto-negotiate
Note: For this parameter to take effect, a device reset is required.
[MIIRedundancyEnable]
Enables the Ethernet Interface Redundancy feature. When enabled, the
device performs a switchover to the second (redundant) Ethernet port
upon upon sensing a link failure in the primary Ethernet port. When
disabled, the device operates with a single port (i.e. no redundancy
support).
 [0] = Disable
 [1] = (Default) Enable
For more information on Ethernet interface redundancy, see Ethernet
Interface Redundancy on page 105.
Note: For this parameter to take effect, a device reset is required.