User's Manual 78 Document #: LTRT-68822
Mediant 2000
Sub-Command Arguments Description
set src
<number> Sets the Source Number for the test call.
set cid
<display string> Sets the Display Name for the test call.
set DTMFs
<DTMF pattern> Sets the pattern of DTMFs that is played to the PSTN side
after the test call is connected.
display
- Displays all the set parameters for the test call. These values
can be manually set using the set commands or defaults.
connect
<destination
number> <source
number> <caller
ID> <time>
Generates the test call toward the PSTN side using the set
parameters. If no arguments are defined in the connect
command line, the test call uses the values defined using the
set commands (or defaults).
Note: There is no option for defining only the <time> value
without specifying all the other arguments that appear before it.
Example:
/SIP>tc
TestCall - TC
Manage Test Tel-Link Call.
Usage:
TC set dest <number>
TC set src <number>
TC set cid <display string>
TC set DTMFs <dtmf string>
TC display
TC connect [dest-number] [src number] [CID] [time]
/SIP>tc display
Test Call configuration
Dest number: 402
Src number: 700
Cid display: TESTING
DTMFs String 112233
Time After DTMF are sent: 20 sec
/SIP>tc connect
Start Test call.
Receive ALERT Event
Receive Connect
Wait more 20 seconds before disconnecting
Receive SS_TIMER_EV Event
Send Release To Call
Receive RELEASE_ACK Event
Receive SS_TIMER_EV Event
5.4.4 Management Commands
The commands under the MGmt directory, described in the table below, display current
performance values.
Table 6: CLI Management Command
Command Short Format Arguments Description
/MGmt/PERFormance
/mg/perf basic | control | dsp |
net | ds1 | reset
Displays performance statistics.
The reset argument clears all
statistics to zero.
To Next Page
Loading...
Need help?
General
