Version 6.6 83 Mediant 2000
User's Manual 6. SNMP-Based Management
SNMP Trap Destinations Parameters Description
Parameter Description
Web: SNMP Manager
[SNMPManagerIsUsed_x
]
Enables the SNMP Manager to receive traps and checks the validity of
the configured destination (IP address and port number).
 [0] (check box cleared) = (Default) Disables SNMP Manager
 [1] (check box selected) = Enables SNMP Manager
Web: IP Address
[SNMPManagerTableIP_
x]
Defines the IP address (in dotted-decimal notation, e.g., 108.10.1.255)
of the remote host used as the SNMP Manager. The device sends
SNMP traps to this IP address.
Trap Port
[SNMPManagerTrapPort
_x]
Defines the port number of the remote SNMP Manager. The device
sends SNMP traps to this port.
The valid value range is 100 to 4000. The default is 162.
Web: Trap User
[SNMPManagerTrapUser
]
Associates a trap user with the trap destination. This determines the
trap format, authentication level, and encryption level.
 v2cParams (default) = SNMPv2 user community string
 SNMPv3 user configured in 'Configuring SNMP V3 Users' on page
84
Trap Enable
[SNMPManagerTrapSen
dingEnable_x]
Activates the sending of traps to the SNMP Manager.
 [0] Disable
 [1] Enable (Default)
6.3 Configuring SNMP Trusted Managers
The SNMP Trusted Managers page allows you to configure up to five SNMP Trusted
Managers, based on IP addresses. By default, the SNMP agent accepts SNMP Get and
Set requests from any IP address, as long as the correct community string is used in the
request. Security can be enhanced by using Trusted Managers, which is an IP address
from which the SNMP agent accepts and processes SNMP requests.
Notes: The SNMP Trusted Managers table can also be configured using the table ini
file parameter, SNMPTrustedMgr_x (see 'SNMP Parameters' on page 517).
To Next Page
Loading...
Need help?
General
