Version 6.6 267 Mediant 2000
User's Manual 21. Digital PSTN
Parameter Description
 [0] No = Don't collect ANI.
 [1] Yes = Collect ANI.
 [-1] Default = Default value - use value from CAS state machine.
Digit Signaling System
[CasStateMachineDigitSign
alingSystem]
Defines which Signaling System to use in both directions
(detection\generation).
 [0] DTMF = Uses DTMF signaling.
 [1] MF = Uses MF signaling (default).
 [-1] Default = Default value - use value from CAS state machine.
21.4 Configuring Digital Gateway Parameters
The Digital Gateway Parameters page allows you to configure miscellaneous digital
parameters. For a description of these parameters, see 'Configuration Parameters
Reference' on page 503.
 To configure the digital gateway parameters:
1. Open the Digital Gateway Parameters page (Configuration tab > VoIP menu > GW
and IP to IP submenu > Digital Gateway submenu > Digital Gateway Parameters).
Figure 21-5: Digital Gateway Parameters Page
2. Configure the parameters as required.
To Next Page
Loading...
Need help?
General
