AudioCodes Mediant 2000 User Manual

Version 6.6 583 Mediant 2000
User's Manual 45. Configuration Parameters Reference
Parameter Description
TelProfile_TimeForReor
derTone
Time For Reorder Tone TimeForReorderTone
TelProfile_EnableDIDW
ink
Enable DID Wink EnableDIDWink
TelProfile_IsTwoStage
Dial
Dialing Mode IsTwoStageDial
TelProfile_DisconnectO
nBusyTone
Disconnect Call on
Detection of Busy Tone
DisconnectOnBusyTone
TelProfile_EnableVoice
MailDelay
Enable Voice Mail
Delay
-
TelProfile_DialPlanInde
x
Dial Plan Index DialPlanIndex
TelProfile_Enable911P
SAP
Enable 911 PSAP Enable911PSAP
TelProfile_SwapTelToIp
PhoneNumbers
Swap Tel To IP Phone
Numbers
SwapTEl2IPCalled&CallingNumb
ers
TelProfile_EnableAGC Enable AGC EnableAGC
TelProfile_ECNlpMode EC NLP Mode ECNLPMode
TelProfile_DigitalCutThr
ough
- DigitalCutThrough
TelProfile_EnableFXOD
oubleAnswer
- EnableFXODoubleAnswer
TelProfile_CallPriorityM
ode
- CallPriorityMode
45.10 Channel Parameters
This subsection describes the device's channel parameters.
45.10.1 Voice Parameters
The voice parameters are described in the table below.
Voice Parameters
Parameter Description
Web/EMS: Input Gain
[InputGain]
Defines the pulse-code modulation (PCM) input gain control (in
decibels). This parameter sets the level for the received (PSTN-
to-IP) signal.
The valid range is -32 to 31 dB. The default is 0 dB.
Note: This parameter can also be configured in an IP Profile
and/or a Tel Profile.
Web: Voice Volume
EMS: Volume (dB)
[VoiceVolume]
Defines the voice gain control (in decibels). This parameter sets
the level for the transmitted (IP-to-PSTN) signal.
The valid range is -32 to 31 dB. The default is 0 dB.
Note: This parameter can also be configured in an IP Profile
and/or a Tel Profile.

AudioCodes Mediant 2000 Specifications

General

Brand	AudioCodes
Model	Mediant 2000
Category	Gateway
Language	English