AudioCodes Mediant 2000 User Manual

User's Manual 526 Document #: LTRT-68822
Mediant 2000
45.3.4 Resource Allocation Indication Parameters
The Resource Allocation Indication (RAI) parameters are described in the table below.
RAI Parameters
Parameter Description
[EnableRAI]
Enables RAI alarm generation if the device's busy endpoints exceed a
user-defined threshold.
 [0] = (Default) Disable RAI (Resource Available Indication) service.
 [1] = RAI service enabled and an SNMP
'acBoardCallResourcesAlarm' Alarm Trap is sent.
[RAIHighThreshold]
Defines the high threshold percentage of total calls that are active (busy
endpoints). When the percentage of the device's busy endpoints
exceeds this high threshold, the device sends the SNMP
acBoardCallResourcesAlarm alarm trap with a 'major' alarm status.
The range is 0 to 100. The default is 90.
Note: The percentage of busy endpoints is calculated by dividing the
number of busy endpoints by the total number of “enabled” endpoints
(trunks are physically connected and synchronized with no alarms and
endpoints are defined in the Trunk Group Table).
[RAILowThreshold]
Defines the low threshold percentage of total calls that are active (busy
endpoints).
When the percentage of the device's busy endpoints falls below this low
threshold, the device sends an SNMP acBoardCallResourcesAlarm
alarm trap with a 'cleared' alarm status.
The range is 0 to 100%. The default is 90%.
[RAILoopTime]
Defines the time interval (in seconds) that the device periodically
checks call resource availability.
The valid range is 1 to 200. The default is 10.
45.3.5 BootP Parameters
The BootP parameters are described in the table below. The BootP parameters are special
'hidden' parameters. Once defined and saved in the device's flash memory, they are used
even if they don't appear in the ini file.
BootP Parameters
Parameter Description
[BootPRetries]
Note: For this parameter to take effect, a device reset is required.
This parameter is used to:
Defines the number of BootP
requests that the device sends
during start-up. The device stops
sending BootP requests when
either BootP reply is received or
number of retries is reached.
 [1] = 1 BootP retry, 1 sec.
 [2] = 2 BootP retries, 3 sec.

[3] = (Default) 3 BootP retries,
Defines the number of DHCP
packets that the device sends. If
after all packets are sent there's
still no reply, the device loads from
flash.
 [1] = 4 DHCP packets
 [2] = 5 DHCP packets
 [3] = (Default) 6 DHCP packets

AudioCodes Mediant 2000 Specifications

General

Brand	AudioCodes
Model	Mediant 2000
Category	Gateway
Language	English