User's Manual 198 Document #: LTRT-68822
Mediant 2000
Time Band Table Description
Parameter Description
Index
[CostGroupTimebands
_TimebandIndex]
Defines the table index entry.
Start Time
[CostGroupTimebands
_StartTime]
Defines the day and time of day from when this time band is applicable.
The format is ddd:hh:mm (e.g., sun:06:00), where:
 ddd is the day (i.e., sun, mon, tue, wed, thu, fri, or sat)
 hh and mm denote the time of day, where hh is the hour (00-23) and
mm the minutes (00-59)
End Time
[CostGroupTimebands
_EndTime]
Defines the day and time of day until when this time band is applicable.
For a description of the valid values, see the parameter above.
Connection Cost
[CostGroupTimebands
_ConnectionCost]
Defines the call connection cost during this time band. This is added as a
fixed charge to the call.
The valid value range is 0-65533. The default is 0.
Note: The entered value must be a whole number (i.e., not a decimal).
Minute Cost
[CostGroupTimebands
_MinuteCost]
Defines the call cost per minute charge during this timeband.
The valid value range is 0-65533. The default is 0.
Note: The entered value must be a whole number (i.e., not a decimal).
14.2.2.4 Assigning Cost Groups to Routing Rules
Once you have configured your Cost Groups, you need to assign them to routing rules in
the Outbound IP Routing table - see Configuring Outbound IP Routing Table on page 309.
To Next Page
Loading...
Need help?
General
