AudioCodes Mediant 2000

Version 6.6 625 Mediant 2000
User's Manual 45. Configuration Parameters Reference
Parameter Description
[TDMBusPSTNAutoClockRev
ertingEnable]
TDMBusLocalReference parameter), the local reference reverts
to the trunk with the higher priority that has returned to service for
the device's clock source.
 [0] Disable (default)
 [1] Enable
Notes:
 For this parameter to take effect, a device reset is required.
 This parameter is applicable only when the
TDMBusPSTNAutoClockEnable parameter is set to 1.
Web: Auto Clock Trunk Priority
EMS: Auto Trunk Priority
[AutoClockTrunkPriority]
Defines the trunk priority for auto-clock fallback (per trunk
parameter).
 0 to 99 = priority, where 0 (default) is the highest.
 100 = the SW never performs a fallback to that trunk (usually
used to mark untrusted source of clock).
Note: Fallback is enabled when the
TDMBusPSTNAutoClockEnable parameter is set to 1.
45.11.6.3 CAS Parameters
The Common Channel Associated (CAS) parameters are described in the table below.
CAS Parameters
Parameter Description
Web: CAS Transport Type
EMS: CAS Relay Transport
Mode
[CASTransportType]
Determines the ABCD signaling transport type over IP.
 [0] CAS Events Only = (Default) Disable CAS relay.
 [1] CAS RFC2833 Relay = Enable CAS relay mode using RFC
2833.
The CAS relay mode can be used with the TDM tunneling feature
to enable tunneling over IP for both voice and CAS signaling
bearers.
[CASAddressingDelimiters]
Enables the addition of delimiters to the received address or
received ANI digits string.
 [0] = (default) Disable. The address and ANI strings remain
without delimiters.
 [1] = Enable. Delimiters such as '*', '#', and 'ST' are added to
the received address or received ANI digits string.
[CASDelimitersPaddingUsag
e]
Defines the digits string delimiter padding usage per trunk.
 [0] = (Default) Default address string padding: '*XXX#' (where
XXX is the digit string that begins with '*' and ends with '#',
when using padding).
 [1] = Special use of asterisks delimiters: '*XXX*YYY*' (where
XXX is the address, YYY is the source phone number, and '*'
is the only delimiter padding).
Note: For this parameter to take effect, a device reset is required.
Web: CAS Table per Trunk
EMS: Trunk CAS Table Index
[CASTableIndex_x]
Defines the CAS protocol per trunk from a list of CAS protocols
defined by the parameter CASFileName_x.
For example, the below configuration specifies Trunks 0 and 1 to