AudioCodes Mediant 2000 User Manual

Version 6.6 251 Mediant 2000
User's Manual 20. IP-to-IP Routing Application

Configure the number of media channels (see 'Step 2: Configure the Number of Media
Channels' on page
251).

Configure a Trunk Group for interfacing with the local PSTN (see 'Step 3: Define a
Trunk Group for the Local PSTN' on page
252).

Configure Proxy Sets (see 'Step 4: Configure the Proxy Sets' on page 252).

Configure IP Groups (see 'Step 5: Configure the IP Groups' on page 254).

Configure Registration Accounts (see 'Step 6: Configure the Account Table' on page
255).

Configure IP Profiles (see 'Step 7: Configure IP Profiles for Voice Coders' on page
256).

Configure inbound IP routing rules (see 'Step 8: Configure Inbound IP Routing' on
page
257).

Configure outbound IP routing rules (see 'Step 9: Configure Outbound IP Routing' on
page
259).

Configure destination phone number manipulation (see 'Step 10: Configure
Destination Phone Number Manipulation' on page
260).
20.2.1 Step 1: Enable the IP-to-IP Capabilities
This step describes how to enable the device's IP-to-IP application.
 To enable IP-to-IP capabilities:
1. Open the Applications Enabling page (Configuration tab > VoIP menu >
Applications Enabling submenu > Applications Enabling).
2. From the 'IP to IP Application' drop-down list, select Enable.
3. Click Submit.
4. Save the setting to flash memory ("burn") with a device reset.
Note: For the IP-to-IP Application feature, the device must also be installed with the
appropriate Software License Key.
20.2.2 Step 2: Configure the Number of Media Channels
The number of media channels represents the number of digital signaling processors
(DSP) channels that the device allocates to IP-to-IP calls. The remaining DSP channels
can be used for PSTN calls. Two IP media channels are used per IP-to-IP call.
 To configure the number of media channels:
1. Open the IP Media Settings page (Configuration tab > VoIP menu > IP Media > IP
Media Settings).
Figure 20-6: Defining Required Media Channels
2. In the 'Number of Media Channels' field, enter the required number of media channels
(in the example above, "120" to enable up to 60 IP-to-IP calls).
3. Click Submit.

AudioCodes Mediant 2000 Specifications

General

Brand	AudioCodes
Model	Mediant 2000
Category	Gateway
Language	English