User's Manual 538 Document #: LTRT-68822
Mediant 2000
45.4.8 IDS Parameters
The Intrusion Detection System (IDS) parameters are described in the table below.
Table 45-1: IDS Parameters
Parameter Description
Web: Intrusion Detection
System (IDS)
CLI: enable-ids
[EnableIDS]
Enables the IDS feature.
 [0] Disable (default)
 [1] Enable
Note: For this parameter to take effect, a device reset is required.
CLI: ids-clear-period
[IDSAlarmClearPeriod]
Defines the interval (in seconds) after which an IDS alarm is cleared from
the Active Alarms table if no thresholds are crossed during this time.
However, this "quiet" period must be at least twice the
value. For example, if IDSAlarmClearPeriod is set to 20 sec and the
Threshold Window is set to 15 sec, the IDSAlarmClearPeriod parameter
is ignored and the alarm is cleared only after 30 seconds (2 x 15 sec).
The valid value is 0 to 86400. The default is 300.
IDS Policy Table
Web: IDS Policy Table
[IDSPolicy]
Defines IDS Policies.
The format of the ini file parameter is:
[ IDSPolicy ]
FORMAT IDSPolicy_Index = IDSPolicy_Name, IDSPolicy_Description;
[ \IDSPolicy ]
For a detailed description of this table, see 'Configuring IDS Policies' on
page 145.
IDS Rule Table
Web: IDS Rule Table
[IDSRule]
Defines rules for the IDS Policies.
The format of the ini file parameter is:
[ IDSRule ]
FORMAT IDSRule_Index = IDSRule_Policy, IDSRule_RuleID,
IDSRule_Reason, IDSRule_ThresholdScope,
IDSRule_ThresholdWindow, IDSRule_MinorAlarmThreshold,
IDSRule_MajorAlarmThreshold, IDSRule_CriticalAlarmThreshold;
[ \IDSRule ]
For a detailed description of this table, see 'Configuring IDS Policies' on
page 145.
IDS Match Table
Web: IDS Match Table
[IDSMatch]
Defines target rules per IDS Policy.
The format of the ini file parameter is:
[ IDSMatch ]
FORMAT IDSMatch_Index = IDSMatch_SIPInterface,
IDSMatch_ProxySet, IDSMatch_Subnet, IDSMatch_Policy;
[ \IDSMatch ]
For a detailed description of this table, see 'Assigning IDS Policies' on
page 148.
To Next Page
Loading...
Need help?
General
