User's Manual 42 Document #: LTRT-68822
Mediant 2000
4.1.6.2 Viewing Parameters
Some pages allow you to view a reduced or expanded display of parameters. The Web
interface provides two methods for displaying page parameters:
Displaying "basic" and "advanced" parameters - see 'Displaying Basic and Advanced
Parameters' on page
42
Displaying parameter groups - see 'Showing / Hiding Parameter Groups' on page 43
4.1.6.2.1 Displaying Basic and Advanced Parameters
Some pages provide a toggle button that allows you to show and hide parameters that
typically are used only in certain deployments. This button is located on the top-right corner
of the page and has two display states:
Advanced Parameter List button with down-pointing arrow: click this button to
display all parameters.
Basic Parameter List button with up-pointing arrow: click this button to show only
common (basic) parameters.
The figure below shows an example of a page displaying basic parameters only. If you
click the Advanced Parameter List button (shown below), the page will also display the
advanced parameters.
Figure 4-7: Toggling between Basic and Advanced View
Notes:
• When the Navigation tree is in Full mode (see 'Navigation Tree' on page 39),
configuration pages display all their parameters.
• If a page contains only basic parameters, the Basic Parameter List button is not
displayed.
• If you reset the device, the Web pages display only the basic parameters.
• The basic parameters are displayed in a dark blue background.
To Next Page
Loading...
Need help?
General
