AudioCodes Mediant 2000 User Manual

Version 6.6 553 Mediant 2000
User's Manual 45. Configuration Parameters Reference
Parameter Description
Note: TCP keepalive is enabled per SIP Interface in the SIP Interface
table.
TCP Keep Alive Retry
Number
[TCPKeepAliveRetry]
Defines the number of unacknowledged keep-alive probes to send
before considering the connection down.
The valid value is 1 to 100. The default is 5.
Note: TCP keepalive is enabled per SIP Interface in the SIP Interface
table.
NAT Translation Table
Web: NAT Translation
Table
[NATTranslation]
This table parameter defines NAT rules for translating source IP
addresses per VoIP interface (SIP control and RTP media traffic) into
NAT IP addresses. This allows, for example, the separation of VoIP
traffic between different ISTP’s, and topology hiding (of internal IP
addresses to the “public” network). Each IP interface (configured in the
Multiple Interface table - InterfaceTable parameter) can be associated
with a NAT rule in this table, translating the source IP address and port
of the outgoing packet into the NAT address (IP address and port
range).
The format of this parameter is as follows:
[ NATTranslation ]
FORMAT NATTranslation_Index =
NATTranslation_SourceIPInterfaceName,
NATTranslation_TargetIPAddress, NATTranslation_SourceStartPort,
NATTranslation_SourceEndPort, NATTranslation_TargetStartPort,
NATTranslation_TargetEndPort;
[ \NATTranslation ]
Note: For a detailed description of this table, see 'Configuring NAT
Translation per IP Interface' on page 127.
45.8 General SIP Parameters
The general SIP parameters are described in the table below.
General SIP Parameters
Parameter Description
Web: SIP Remote Reset
CLI: sip-remote-reset
[EnableSIPRemoteReset
]
Enables a specific device action upon the receipt of a SIP NOTIFY
request, where the action depends on the value received in the Event
header.
 [0] Disable (default)
 [1] Enable
The action depends on the Event header value:
 'check-sync;reboot=false': triggers the regular Automatic Update
feature (if Automatic Update has been enabled on the device)
 'check-sync;reboot=true': triggers a device reset
Note: The Event header value is proprietary to AudioCodes.
Web/EMS: Max SIP
Message Length [KB]
[MaxSIPMessageLength
Defines the maximum size (in Kbytes) for each SIP message that can
be sent over the network. The device rejects messages exceeding this
user-defined size.

AudioCodes Mediant 2000 Specifications

General

Brand	AudioCodes
Model	Mediant 2000
Category	Gateway
Language	English