User's Manual 652 Document #: LTRT-68822
Mediant 2000
Parameter Description

[1] Packets Count = According to packet count.
Note: For this parameter to take effect, a device reset is required.
[FarEndDisconnectSile
nceThreshold]
Defines the threshold of the packet count (in percentages) below which
is considered silence by the device.
The valid range is 1 to 100%. The default is 8%.
Notes:
 This parameter is applicable only if silence is detected according to
packet count (FarEndDisconnectSilenceMethod is set to 1).
 For this parameter to take effect, a device reset is required.
[BrokenConnectionDur
ingSilence]
Enables the generation of the BrokenConnection event during a silence
period if the channel’s NoOp feature is enabled (using the parameter
NoOpEnable) and if the channel stops receiving NoOp RTP packets.
 [0] Disable (default)
 [1] Enable
Web: Trunk Alarm Call
Disconnect Timeout
[TrunkAlarmCallDiscon
nectTimeout]
Defines the duration (in seconds) to wait after an E1/T1 trunk "Red"
alarm (LOS / LOF) is raised, before the device disconnects the SIP call.
If this timeout expires and the alarm is still raised, the device sends a
SIP BYE message to terminate the call. If the alarm is cleared before
this timeout expires, the call is not terminated, but continues as normal.
The range is 1 to 3600. The default is 0 (20 for E1 and 40 for T1).
Web: Disconnect Call on
Busy Tone Detection
(ISDN)
EMS: Isdn Disconnect
On Busy Tone
[ISDNDisconnectOnBu
syTone]
Determines whether a call is disconnected upon detection of a busy
tone (for ISDN).
 [0] Disable = (Default) Do not disconnect call upon detection of busy
tone.
 [1] Enable = Disconnect call upon detection of busy tone.
Notes:
 This parameter is applicable only to ISDN protocols.
 IP-to-ISDN calls are disconnected on detection of SIT tones only in
call alert state. If the call is in connected state, the SIT does not
disconnect the calls. Detection of busy or reorder tones disconnects
the IP-to-ISDN calls also in call connected state.
 For IP-to-CAS calls, detection of busy, reorder, or SIT tones
disconnect the calls in any call state.
Web: Disconnect Call on
Busy Tone Detection
(CAS)
EMS: Disconnect On
Detection End Tones
[DisconnectOnBusyTo
ne]
Determines whether a call is disconnected upon detection of a busy
tone.
 [0] Disable = Call is not disconnected upon detection of a busy tone.
 [1] Enable = (Default) Call is released upon detection of busy or
reorder (fast busy) tone.
Notes:
 This parameter is applicable only to CAS protocols.
 This parameter is also applicable to the IP-to-IP application.
 This parameter can also be configured in a Tel Profile.
To Next Page
Loading...
Need help?
General
