Version 6.6 299 Mediant 2000
User's Manual 23. Manipulation
Parameter Description
 This parameter is applicable only to the Redirect Number IP > Tel
table.
 Use the wildcard asterisk (*) symbol to denote any prefix.
Operation (Action)
Web: Stripped Digits From
Left
EMS: Remove From Left
[RemoveFromLeft]
Defines the number of digits to remove from the left of the redirect
number prefix. For example, if you enter 3 and the redirect number is
5551234, the new number is 1234.
Web: Stripped Digits From
Right
EMS: Remove From Right
[RemoveFromRight]
Defines the number of digits to remove from the right of the redirect
number prefix. For example, if you enter 3 and the redirect number is
5551234, the new number is 5551.
Web/EMS: Number of
Digits to Leave
[LeaveFromRight]
Defines the number of digits that you want to retain from the right of
the redirect number.
Web/EMS: Prefix to Add
[Prefix2Add]
Defines the number or string that you want added to the front of the
redirect number. For example, if you enter 9 and the redirect number
is 1234, the new number is 91234.
Web/EMS: Suffix to Add
[Suffix2Add]
Defines the number or string that you want added to the end of the
redirect number. For example, if you enter 00 and the redirect number
is 1234, the new number is 123400.
Web: Presentation
EMS: Is Presentation
Restricted
[IsPresentationRestricted
]
Enables caller ID.

 [0] Allowed = Sends Caller ID information when a call is made
using these destination / source prefixes.
 [1] Restricted = Restricts Caller ID information for these prefixes.
Note: If 'Presentation' is set to 'Restricted' and the AssertedIdMode
parameter is set to Add P-Asserted-Identity, the From header in the
INVITE message includes the following: From: 'anonymous' <sip:
anonymous@anonymous.invalid> and 'privacy: id' header.
Web: TON
EMS: Number Type
[NumberType]
Defines the Type of Number (TON).
The default is 'Unknown' [0].
 If you select 'Unknown' for the NPI, you can select Unknown [0].
 If you select 'Private' for the NPI, you can select Unknown [0],
International [1], National [2], Network Specific [3] or Subscriber
[4].
 If you select 'E.164 Public' for the NPI, you can select Unknown
[0], International [1], National [2], Network Specific [3], Subscriber
[4] or Abbreviated [6].
Notes:
 This parameter is applicable only to the Redirect Number IP > Tel
table.
 For more information on available NPI/TON values, see
Numbering Plans and Type of Number on page 307.
To Next Page
Loading...
Need help?
General
