User's Manual 380 Document #: LTRT-68822
Mediant 2000
Parameter Description
table, see 'Configuring IP Groups' on page 204). If this table does not
define an IP Group but only an SRD, then the first IP Group
associated with this SRD (in the IP Group table) is used.
 If the selected destination IP Group ID is type SERVER, the request
is routed according to the IP Group addresses.
 If the selected destination IP Group ID is type USER, the request is
routed according to the IP Group specific database (i.e., only to
registered users of the selected database).
 If the selected destination IP Group ID is ANY USER ([-2]), the
request is routed according to the general database (i.e., any
matching registered user).
Destination Address
[IP2IPRouting_DestAdd
ress]
Defines the destination IP address (or domain name, e.g., domain.com)
to where the call is sent. If ENUM-based routing is used (i.e., the
'Destination Type' parameter is set to ENUM) this parameter defines the
IP address or domain name (FQDN) of the ENUM service, for example,
e164.arpa, e164.customer.net, or NRENum.net. The device sends the
ENUM query containing the destination phone number to an external
DNS server, configured in the Multiple Interface table. The ENUM reply
includes a SIP URI (user@host) which is used as the destination
Request-URI in this routing table.
Notes:
 This parameter is applicable only if the parameter 'Destination Type'
is set to 'Dest Address' [1] or ENUM [3].
 When using domain names, enter a DNS server IP address or
alternatively, define these names in the 'Internal DNS Table' (see
'Configuring the Internal SRV Table' on page 122).
Destination Port
[IP2IPRouting_DestPor
t]
Defines the destination port to where the call is sent.
Destination Transport
Type
[IP2IPRouting_DestTra
nsportType]
Defines the transport layer type for sending the call:
 [-1] Not Configured (default)
 [0] UDP
 [1] TCP
 [2] TLS
Note: When this parameter is set to -1, the transport type is determined
by the parameter SIPTransportType.
Cost Group
[IP2IPRouting_CostGro
up]
Assigns a Cost Group to the routing rule for determining the cost of the
call. To configure Cost Groups, see 'Configuring Cost Groups' on page
196.
By default, no Cost Group is assigned to the rule.
To Next Page
Loading...
Need help?
General
