AudioCodes Mediant 2000

Version 6.6 547 Mediant 2000
User's Manual 45. Configuration Parameters Reference
Parameter Description

[2] Full = Caches all challenges from the proxies.
Note: Challenge Caching is used with all proxies and not only with the
active one.
Proxy IP Table
Web: Proxy IP Table
EMS: Proxy IP
[ProxyIP]
This table parameter configures the Proxy Set table with Proxy Set IDs,
each with up to five Proxy server IP addresses (or fully qualified domain
name/FQDN). Each Proxy Set can be defined with a transport type
(UDP, TCP, or TLS). The format of this parameter is as follows:
[ProxyIP]
FORMAT ProxyIp_Index = ProxyIp_IpAddress, ProxyIp_TransportType,
ProxyIp_ProxySetId;
[\ProxyIP]
For example:
ProxyIp 0 = 10.33.37.77, -1, 0;
ProxyIp 1 = 10.8.8.10, 0, 2;
ProxyIp 2 = 10.5.6.7, -1, 1;
Notes:
 To assign various attributes (such as Proxy Load Balancing) per
Proxy Set ID, use the parameter ProxySet.
 For a description of this table, see 'Configuring Proxy Sets Table' on
page 209.
Proxy Set Table
Web: Proxy Set Table
EMS: Proxy Set
[ProxySet]
This table parameter configures the Proxy Set ID table. It is used in
conjunction with the ProxyIP table ini file parameter, which defines the
IP addresses per Proxy Set ID.
The ProxySet table ini file parameter defines additional attributes per
Proxy Set ID. This includes, for example, Proxy keep-alive and load
balancing and redundancy mechanisms (if a Proxy Set contains more
than one proxy address).
The format of this parameter is as follows:
[ProxySet]
FORMAT ProxySet_Index = ProxySet_EnableProxyKeepAlive,
ProxySet_ProxyKeepAliveTime, ProxySet_ProxyLoadBalancingMethod,
ProxySet_IsProxyHotSwap, ProxySet_SRD,
ProxySet_ClassificationInput, ProxySet_ProxyRedundancyMode;
[\ProxySet]
For example:
ProxySet 0 = 0, 60, 0, 0, 0, , 1;
ProxySet 1 = 1, 60, 1, 0, 1, , 0;
Notes:
 For configuring the Proxy Set IDs and their IP addresses, use the
parameter ProxyIP.
 For a description of this table, see 'Configuring Proxy Sets Table' on
page 209.
Registrar Parameters
Web: Enable Registration
EMS: Is Register Needed
[IsRegisterNeeded]
Enables the device to register to a Proxy/Registrar server.
 [0] Disable = (Default) The device doesn't register to Proxy/Registrar
server.
 [1] Enable = The device registers to Proxy/Registrar server when the
device is powered up and at every user-defined interval (configured