AudioCodes Mediant 2000 User Manual

Version 6.6 557 Mediant 2000
User's Manual 45. Configuration Parameters Reference
Parameter Description
Conversely, if EnableEarlyMedia is set to 0, the device disconnects the
call by sending a SIP 4xx response to the originating party. However, if
the ReleaseIP2ISDNCallOnProgressWithCause parameter is set to 1,
then the device sends a SIP 4xx response even if the
EnableEarlyMedia parameter is set to 1.
 [0] = (Default) If a Progress with Cause message is received from
the PSTN for an outgoing IP-to-ISDN call, the device does not
disconnect the call by sending a SIP 4xx response to the originating
party.
 [1] = The device sends a SIP 4xx response when the
EnableEarlyMedia parameter is set to 0.
 [2] = The device always sends a SIP 4xx response, even if he
EnableEarlyMedia parameter is set to 1.
Web: Session-Expires
Time
EMS: Sip Session Expires
[SIPSessionExpires]
Defines the numerical value sent in the Session-Expires header in the
first INVITE request or response (if the call is answered).
The valid range is 1 to 86,400 sec. The default is 0 (i.e., the Session-
Expires header is disabled).
Web: Minimum Session-
Expires
EMS: Minimal Session
Refresh Value
[MinSE]
Defines the time (in seconds) that is used in the Min-SE header. This
header defines the minimum time that the user agent refreshes the
session.
The valid range is 10 to 100,000. The default is 90.
Web/EMS: Session
Expires Disconnect Time
CLI: session-exp-
disconnect-time
[SessionExpiresDiscon
nectTime]
Defines a session expiry timeout. The device disconnects the session
(sends a SIP BYE) if the refresher does not send a refresh request
before one-third (1/3) of the session expires time, or before the time
configured by this parameter (the minimum of the two).
The valid range is 0 to 32 (in seconds). The default is 32.
Web/EMS: Session
Expires Method
[SessionExpiresMethod]
Determines the SIP method used for session-timer updates.
 [0] Re-INVITE = (Default) Uses Re-INVITE messages for session-
timer updates.
 [1] UPDATE = Uses UPDATE messages.
Notes:
 The device can receive session-timer refreshes using both methods.
 The UPDATE message used for session-timer is excluded from the
SDP body.
[RemoveToTagInFailure
Response]
Determines whether the device removes the ‘to’ header tag from final
SIP failure responses to INVITE transactions.
 [0] = (Default) Do not remove tag.
 [1] = Remove tag.
[EnableRTCPAttribute]
Enables the use of the 'rtcp' attribute in the outgoing SDP.
 [0] = Disable (default)
 [1] = Enable
EMS: Options User Part
[OPTIONSUserPart]
Defines the user part value of the Request-URI for outgoing SIP
OPTIONS requests. If no value is configured, the configuration
parameter ‘Username’ valueis used.
A special value is ‘empty’, indicating that no user part in the Request-

AudioCodes Mediant 2000 Specifications

General

Brand	AudioCodes
Model	Mediant 2000
Category	Gateway
Language	English