AudioCodes Mediant 2000

User's Manual 622 Document #: LTRT-68822
Mediant 2000
Parameter Description

[1] Generated = Generate the clock according to the internal
TDM bus.
Note: The source of the internal TDM bus clock is determined by
the parameter TDMBusClockSource.
[ClockMaster_x]
Same as the description for parameter ClockMaster, but for a
specific Trunk ID (where x denotes the Trunk ID and 0 is the first
Trunk).
Web/EMS: Line Code
[LineCode]
Selects B8ZS or AMI for T1 spans, and HDB3 or AMI for E1
spans.
 [0] B8ZS = (Default) B8ZS line code (for T1 trunks only).
 [1] AMI = AMI line code.
 [2] HDB3 = HDB3 line code (for E1 trunks only).
[LineCode_x]
Same as the description for parameter LineCode, but for a
specific trunk ID (where 0 denotes the first trunk).
[AdminState]
Defines the administrative state for all trunks.
 [0] = Lock the trunk; stops trunk traffic to configure the trunk
protocol type.
 [1] = Shutting down (read only).
 [2] = (Default) Unlock the trunk; enables trunk traffic.
Notes:
 For this parameter to take effect, a device reset is required.
 When the device is locked from the Web interface, this
parameter changes to 0.
 To define the administrative state per trunk, use the
TrunkAdministrativeState parameter.
[TrunkAdministrativeState_x
]
Defines the administrative state per trunk, where x denotes the
trunk number.
 [0] = Lock the trunk; stops trunk traffic to configure the trunk
protocol type.
 [1] = shutting down (read only).
 [2] = (Default) Unlock the trunk; enables trunk traffic.
Web/EMS: Line Build Out Loss
[LineBuildOut.Loss]
Defines the line build out loss for the selected T1 trunk.
 [0] 0 dB (default)
 [1] -7.5 dB
 [2] -15 dB
 [3] -22.5 dB
Note: This parameter is applicable only to T1 trunks.
[TDMHairPinning]
Defines static TDM hair-pinning (cross-connection) performed at
initialization. The connection is between trunks with an option to
exclude a single B-channel in each trunk.
Format example: T0-T1/B3,T2-T3,T4-T5/B2.
Note: For this parameter to take effect, a device reset is required.
Web: Enable TDM Tunneling
EMS: TDM Over IP
[EnableTDMoverIP]
Enables TDM tunneling.
 [0] Disable (default)
 [1] Enable
When TDM Tunneling is enabled, the originating device