AudioCodes Mediant 2000

Version 6.6 629 Mediant 2000
User's Manual 45. Configuration Parameters Reference
Parameter Description

This parameter is applicable only to T1 ISDN protocols.
 The x in the ini file parameter name denotes the trunk number,
where 0 is Trunk 1.
 For more information on NFAS, see 'ISDN Non-Facility
Associated Signaling (NFAS)' on page 272.
Web/EMS: D-channel
Configuration
[DChConfig_x]
Defines primary, backup (optional), and B-channels only, per
trunk.
 [0] PRIMARY= (Default) Primary Trunk - contains a D-channel
that is used for signaling.
 [1] BACKUP = Backup Trunk - contains a backup D-channel
that is used if the primary D-channel fails.
 [2] NFAS = NFAS Trunk - contains only 24 B-channels,
without a signaling D-channel.
Notes:
 This parameter is applicable only to T1 ISDN protocols.
 The x in the ini file parameter name denotes the trunk number,
where 0 is Trunk 1.
Web: NFAS Interface ID
EMS: ISDN NFAS Interface ID
[ISDNNFASInterfaceID_x]
Defines a different Interface ID per T1 trunk.
The valid range is 0 to 100. The default interface ID equals the
trunk's ID.
Notes:
 To set the NFAS interface ID, configure ISDNIBehavior_x to
include '512' feature per T1 trunk.
 The x in the ini file parameter name denotes the trunk number,
where 0 is Trunk 1.
 For more information on NFAS, see 'ISDN Non-Facility
Associated Signaling (NFAS)' on page 272.
Web: Enable ignoring ISDN
Disconnect with PI
[KeepISDNCallOnDisconnect
WithPI]
Allows the device to ignore ISDN Disconnect messages with PI 1
or 8.
 [1] = The call (in connected state) is not released if a Q.931
Disconnect with PI (PI = 1 or 8) message is received during
the call.
 [0] = (Default) The call is disconnected.
Web: PI For Setup Message
[PIForSetupMsg]
Determines whether and which Progress Indicator (PI) information
element (IE) is added to the sent ISDN Setup message. Some
ISDN protocols such as NI-2 or Euro ISDN can optionally contain
PI = 1 or PI = 3 in the Setup message.
 [0] = PI is not added (default).
 [1] = PI 1 is added to a sent ISDN Setup message - call is not
end-to-end ISDN.
 [3] = PI 3 is added to a sent ISDN Setup message - calling
equipment is not ISDN.
ISDN Flexible Behavior Parameters
ISDN protocol is implemented in different switches/PBXs by different vendors. Several
implementations may vary slightly from the specification. Therefore, to provide a flexible interface
that supports these ISDN variants, the ISDN behavior parameters can be used.
Web/EMS: Incoming Calls
Behavior
[ISDNInCallsBehavior]
Determines the bit-field used to determine several behavior
options that influence how the ISDN Stack INCOMING calls
behave.