Version 6.6 633 Mediant 2000
User's Manual 45. Configuration Parameters Reference
Parameter Description
not set (default behavior), CC implements the UUI-protocol as
specified in the ETS 300-403 standards for Implicit Service 1.
 [65536] GTD5 TBCT = CC implements the VERIZON-GTD-5
Switch variant of the TBCT Supplementary Service, as
specified in FSD 01-02-40AG Feature Specification Document
from Verizon. Otherwise, TBCT is implemented as specified in
GR-2865-CORE specification (default behavior).
Note: When using the ini file to configure the device to support
several ISDNGeneralCCBehavior features, add the individual
feature values. For example, to support both [16] and [32]
features, set ISDNGeneralCCBehavior = 48 (i.e., 16 + 32).
Web/EMS: Outgoing Calls
Behavior
[ISDNOutCallsBehavior]
Determines several behaviour options (bit fields) that influence
the behaviour of the ISDN Stack outgoing calls. To select options,
click the arrow button, and then for each required option, select 1
to enable. The default is 0 (i.e., disable).
 [2] USER SENDING COMPLETE =The default behavior of the
device (when this bit is not set) is to automatically generate the
Sending-Complete IE in the Setup message. This behavior is
used when overlap dialing is not needed. When overlap dialing
is needed, set this bit and the behavior is changed to suit the
scenario, i.e., Sending-Complete IE is added when required in
the Setup message for Enblock mode or in the last Digit with
Overlap mode.
 [16] USE MU LAW = The device sends G.711-m-Law in
outgoing voice calls. When disabled, the device sends G.711-
A-Law in outgoing voice calls.
Note: This option is applicable only to the Korean variant.
 [128] DIAL WITH KEYPAD = The device uses the Keypad IE
to store the called number digits instead of the CALLED_NB
IE.
Note: This option is applicable only to the Korean variant
(Korean network). This is useful for Korean switches that don't
accept the CALLED_NB IE.
 [256] STORE CHAN ID IN SETUP = The device forces the
sending of a Channel-Id IE in an outgoing Setup message
even if it's not required by the standard (i.e., optional) and no
Channel-Id has been specified in the establishment request.
This is useful for improving required compatibility with
switches. On PRI lines, it indicates an unused channel ID,
preferred only.
 [572] USE A LAW = The device sends G.711 A-Law in
outgoing voice calls. When disabled, the device sends the
default G.711-Law in outgoing voice calls.
Note: This option is applicable only to the E10 variant.
 [1024] = Numbering plan/type for T1 IP-to-Tel calling numbers
are defined according to the manipulation tables or according
to the RPID header (default). Otherwise, the plan/type for T1
calls are set according to the length of the calling number.
 [2048] = The device accepts any IA5 character in the
called_nb and calling_nb strings and sends any IA5 character
in the called_nb, and is not restricted to extended digits only
(i.e., 0-9,*,#).
 [16384] DLCI REVERSED OPTION = Behavior bit used in the
IUA interface groups to indicate that the reversed format of the
To Next Page
Loading...
Need help?
General
