Version 6.6 645 Mediant 2000
User's Manual 45. Configuration Parameters Reference
Parameter Description

This feature is similar to that of the EnableISDNTunnelingIP2Tel
parameter. If both parameters are configured, the
EnableISDNTunnelingIP2Tel parameter takes precedence.
Web: Trunk Groups to
Send IE
EMS: List Of Trunk
Groups To Send IE
[SendIEonTG]
Defines Trunk Group IDs (up to 50 characters) from where the optional
ISDN IE (defined by the parameter AddIEinSetup) is sent. For example:
'1,2,4,10,12,6'.
Notes:
 You can configure different IE data for Trunk Groups by defining this
parameter for different IP Profile IDs (using the parameter IPProfile),
and then assigning the required IP Profile ID in the Inbound IP
Routing Table (PSTNPrefix).
 When IP Profiles are used for configuring different IE data for Trunk
Groups, this parameter is ignored.
Web: Enable User-to-
User IE for Tel to IP
EMS: Enable UUI Tel 2
Ip
[EnableUUITel2IP]
Enables transfer of User-to-User (UU) IE from ISDN PRI to SIP.
 [0] Disable (default)
 [1] Enable
The device supports the following ISDN PRI-to-SIP interworking: Setup
to SIP INVITE, Connect to SIP 200 OK, User Information to SIP INFO,
Alerting to SIP 18x response, and Disconnect to SIP BYE response
messages.
Note: The interworking of ISDN User-to-User IE to SIP INFO is
applicable only to the Euro ISDN, QSIG, and 4ESS PRI variants.
Web: Enable User-to-
User IE for IP to Tel
EMS: Enable UUI Ip 2
Tel
[EnableUUIIP2Tel]
Enables interworking of SIP user-to-user information (UUI) to User-to-
User IE in ISDN Q.931 messages.
 [0] Disable = (Default) Received UUI is not sent in ISDN message.
 [1] Enable = The device interworks UUI from SIP to ISDN
messages. The device supports the following SIP-to-ISDN
interworking of UUI:
SIP INVITE to Q.931 Setup
SIP REFER to Q.931 Setup
SIP 200 OK to Q.931 Connect
SIP INFO to Q.931 User Information
SIP 18x to Q.931 Alerting
SIP BYE to Q.931 Disconnect
Notes:
 The interworking of ISDN User-to-User IE to SIP INFO is applicable
only to the Euro ISDN, QSIG, and 4ESS PRI variants.
 To interwork the UUIE header from SIP-to-ISDN messages with the
4ESS ISDN variant, the ISDNGeneralCCBehavior parameter must
be set to 16384.
[Enable911LocationIdI
P2Tel]
Enables interworking of Emergency Location Identification from SIP to
PRI.
 [0] = Disabled (default)
 [1] = Enabled
When enabled, the From header received in the SIP INVITE is
translated into the following ISDN IE's:
 Emergency Call Control.
 Generic Information - to carry the Location Identification Number
information.

Generic Information - to carry the Calling Geodetic Location
To Next Page
Loading...
Need help?
General
