AudioCodes Mediant 2000

Version 6.6 681 Mediant 2000
User's Manual 45. Configuration Parameters Reference
Parameter Description
Note: If you configure multiple DNs, you can specify whether the
search is done sequentially or in parallel, using the
LDAPSearchDNsinParallel parameter.
[LDAPSearchDNsinParall
el]
Defines the LDAP query DN search method in the AD database if
multiple search DNs are configured, using the LDAPSearchDNs
parameter.
 [0] Sequential = If the first DN search fails, the search is done on
the next configured DN, and so on.
 [1] Parallel (Default)
Web: LDAP Server Max
Respond Time
EMS: Server Max Respond
Time
[LDAPServerMaxRespon
dTime]
Defines the time (in seconds) that the device waits for LDAP server
responses.
The valid value range is 0 to 86400. The default is 3000.
[LDAPDebugMode]
Determines whether to enable the LDAP task debug messages. This
is used for providing debug information regarding LDAP tasks.
The valid value range is 0 to 3. The default is 0.
Web: MS LDAP OCS
Number attribute name
EMS: LDAP ocs Number
Attribute Name
[MSLDAPOCSNumAttrib
uteName]
Defines the name of the attribute that represents the user OCS
number in the Microsoft AD database.
The valid value is a string of up to 49 characters. The default is
"msRTCSIP-PrimaryUserAddress".
Web: MS LDAP PBX
Number attribute name
[MSLDAPPBXNumAttribu
teName]
Defines the name of the attribute that represents the user PBX
number in the Microsoft AD database.
The valid value is a string of up to 49 characters. The default is
"telephoneNumber".
Web: MS LDAP MOBILE
Number attribute name
[MSLDAPMobileNumAttri
buteName]
Defines the name of the attribute that represents the user Mobile
number in the Microsoft AD database.
The valid value is a string of up to 49 characters. The default is
"mobile".
[MSLDAPPrivateNumAttr
ibuteName]
Defines the name of the attribute that represents the user's private
number in the AD. If this value equals the value of the
MSLDAPPrimaryKey or MSLDAPSecondaryKey parameter, then the
device queries the AD for the destination number in this private
attribute name; otherwise, this parameter is not used as a search
key.
The default is "msRTCSIP-PrivateLine".
CLI: ldap-display-nm-attr
[MSLDAPDisplayNameAt
tributeName]
Defines the attribute name that represents the Calling Name in the
AD for LDAP queries based on calling number.
The valid value is a string of up to 49 characters. The default is
"displayName".
[MSLDAPPrimaryKey]
Defines the name of the attribute used as a query search key for the
destination number in the AD. This is used instead of the "PBX"
attribute name (configured by the MSLDAPPBXNumAttributeName
parameter).
The default is not configured.