Baumuller b maXX BM3000 - Page 32

Performing the commissioning
Parameter manual b maXX BM3000
Document no.: 5.12001.07 Baumüller Nürnberg GmbH
32
of 820
2.7
The "Encoder 1 Configuration" window opens.
Figure 15: ProDrive: Encoder 1 configuration
13 Enter data when using a sine-cosine encoder without a HIPERFACE
®
interface. With
a sine-cosine encoder with a HIPERFACE
®
interface, the data are transferred auto-
matically over the HIPERFACE
®
interface - do not alter the data.
m Sine-cosine without HIPERFACE
®
e.g. Number of Pulses = 512
m Sine-cosine without HIPERFACE
®
e.g. Revolutions = 1
14 Enter the overspeed limit manually in the parameter list in the diagnostic block
[FB:006]:

Parameter number 006.005 and 006.007: enter the value 115%,
Parameter number 006.006 and 006.008: enter the value -115%