Baumuller b maXX BM3000 - Description of the Parameters

Description of the Software Modules and Parameters
Parameter manual b maXX BM3000
Document no.: 5.12001.07
259
of 820
4
4.4.16.3 Description of the Parameters
124.1 Configuration mode
Configuration of the measuring encoder
124.5 Encoder 1 trigger digital input
TP1 pos. edge revolutions
UDINT 0 0xFFFFFFFF 0 1:1 X
124.6 Encoder 1 trigger digital input
TP1 pos. edge angle
UDINT 0 0xFFFFFFFF 0 1:1 X
124.7 Encoder 1 trigger digital input
TP1 neg. edge revolutions
UDINT 0 0xFFFFFFFF 0 1:1 X
124.8 Encoder 1 trigger digital input
TP1 neg. edge angle
UDINT 0 0xFFFFFFFF 0 1:1 X
124.9 Encoder 1 trigger digital input
TP2 pos. edge revolutions
UDINT 0 0xFFFFFFFF 0 1:1 X
124.10 Encoder 1 trigger digital input
TP2 pos. edge angle
UDINT 0 0xFFFFFFFF 0 1:1 X
124.11 Encoder 1 trigger digital input
TP2 neg. edge revolutions
UDINT 0 0xFFFFFFFF 0 1:1 X
124.12 Encoder 1 trigger digital input
TP2 neg. edge angle
UDINT 0 0xFFFFFFFF 0 1:1 X
124.13 Encoder 1 trigger zero pulse
pos. edge revolutions
UDINT 0 0xFFFFFFFF 0 1:1 X
124.14 Encoder 1 trigger zero pulse
pos. edge angle
UDINT 0 0xFFFFFFFF 0 1:1 X
124.15 Encoder 1 trigger zero pulse
neg. edge revolutions
UDINT 0 0xFFFFFFFF 0 1:1 X
124.16 Encoder 1 trigger zero pulse
neg. edge angle
UDINT 0 0xFFFFFFFF 0 1:1 X
124.30 DS402 mode UDINT 0 0xFFFFFFFF 0x00100100 1:1 X
124.31 DS402 touch probe 1 pos.
value
UDINT 0 0xFFFFFFFF 0 Inc 1:1 X
124.32 DS402 touch probe 1 neg.
value
UDINT 0 0xFFFFFFFF 0 Inc 1:1 X
124.33 DS402 touch probe 2 pos.
value
UDINT 0 0xFFFFFFFF 0 Inc 1:1 X
124.34 DS402 touch probe 2 neg.
value
UDINT 0 0xFFFFFFFF 0 Inc 1:1 X
NOTE!
All measurements are inactive during the change of the configuration!