INSTALLATION AND STARTUP
1MANUL220 Belanger, Inc.® * PO BOX 5470. * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 1-7
Chapter 1 Introduction
Scope of This Manual
This Introduction Section is intended to:
• Address the installation portion only.
• Help you to understand how the installation manual is organized.
• Encourage planning and organization.
• Address safety issues.
Installation Manual
This is the manual that covers the installation portion of a FreeStyler® system. In this manual there is very little content
as to operation, maintenance, troubleshooting and so on. For those items please reference the FreeStyler®
Maintenance manual and any other supplied support documents.
How the Manual is Organized
The installation manual starts off with a "punch list" of activities that must be performed during the installation phase.
The list is comprehensive and provides a general order in which the tasks should be completed to minimize installation
time.
This list also acts as a directory for the remainder of the manual. Now is a good time to review the Recommended
Installation Sequence checklist in chapter 2.
The last section of the installation manual is concerned with initial startup. A checklist format is provided as a walk-
through of starting up and fine tuning the FreeStyler® system.
Planning and Organization
The installation manual assumes that your Belanger® Representative has already visited the site, taken measurements,
and quite possibly sent drawings showing equipment locations. The installation manual also assumes that all these
items have been thoroughly reviewed by the site General Contractor and Owner. If that is not the case, now is the time
to do so. For your convenience, the "Getting Started" section reiterates some of the critical points of a FreeStyler®
installation. Primarily, the “Getting Started” section addresses equipment placement and electrical considerations to
ensure the FreeStyler® system is installed successfully. If there is a planning question not covered in this manual,
please contact your Belanger® Representative immediately.
Ensure a Safe Work Environment
The job site can be a hectic place. Often deadlines control the pace. Please always keep in mind Job Site Safety. Proper
use of all safety gear (safety glasses, hard-hats, footwear, shields, guards, etc.) is imperative. Be aware of electrical
concerns (exposed conductors, extension cords, proximity to water, power tool maintenance, etc.). Be sure to obey
OSHA Lockout/Tagout procedures (Refer to 29 CFR 1910.147 and the example in 29 CFR 1910.147 Appendix A) and
that everyone on site understands this process. Rigging (forklift operation) is another concern. Minimize slip, trip, and
fall potentials consistently. In short, be aware of OSHA considerations, in addition to rules and regulations put in place
by your local authorities.
It is imperative to your safety and the safety of others to always follow safe work
procedures.
To Next Page
Loading...
