Belanger FreeStyler - General Requirements; Utility Requirements

INSTALLATION AND STARTUP
1MANUL220 Belanger, Inc.® * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 18-1
Chapter 18 Spot Free Rinse (RO) Option
Note: The information in this portion of the document was supplied by Pur-Clean™, A division of New
Wave Industries LTD. Pur-Clean™ equipment is designed for easy installation. However, should
you have any questions, please call New Wave Industries LTD. at (916) 978-9990 or (800) 882-
8854.
General Requirements
1) Provide a covered and/or heated enclosed area with at least 30” x 72” of floor space
2) Electrical, see site specific drawings
3) Plumbing, see site specific drawings
4) 2” drain
Utility Requirements
Note: See the site-specific plumbing layout for more details.
Requirements
Water
• 3/4” water line with Ball
Valve, 20 GPM @ 30 PSI
for RO System
• Drain
Electrical
• Two, 208/220V, 20 Amp,
single-phase circuits, each
with its own L6-20 locking
receptacle. Place this plug
60” up from the floor on the
right side of the RO unit.
64”
72”
23”
24”
36”
100-Gallon
Tank
Front View
Top View