INSTALLATION AND STARTUP
3-18 Belanger, Inc.® * PO BOX 5470. * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL220
Chapter 3 Getting Started
Fastening Needs and Other Required Materials
Due to the variables from site to site (wall thickness, wall type, slab heat, weld plates, etc.)
Belanger, Inc.® has no way to anticipate your FreeStyler® fastening needs. Below is a
recommendation of fastener types and quantities required for installation. All the fasteners listed
are typically available at an Industrial or Commercial supplier or can be purchased through the
Belanger® Aftermarket group.
Note: Please be aware that the typical “home do-it-all” stores rarely carry stainless steel and/or
heavy grade fasteners, therefore you should plan accordingly.
• The FreeStyler® Floor Mounted system is designed to be secured with 5/8” lag bolts.
Note: Hydraulic hoses are rated by “bend radius” and “PSI”, however this document uses PSI to
rate hoses.
Other field supplied items that will be required, depending on the level of your installation, including
water hose, poly-flow tubing, hydraulic hose assemblies and other plumbing lines. All these items
are also typically available at an Industrial or Commercial supplier or can be purchased through
the Belanger® Aftermarket group.
Base FreeStyler®
To Next Page
Loading...
