INSTALLATION AND STARTUP
1MANUL220 Belanger, Inc.® * PO BOX 5470. * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 3-19
Chapter 3 Getting Started
FreeStyler® Utility Recommendations Floor Mounted
The following is a list of hardware and/or utility supplies needed to successfully install a FreeStyler®
floor mounted system.
We recommend using the following:
• Threaded rod, back plates, washers and nuts to mount and secure the Wall Boom mount.
• High quality 1/2" by 3-3/4” lag bolts for the Undercarriage
• 3/8” anchors to mount the SDM panel and Signs
• Hose clamps and tie wraps are also suggested for your convenience.
• Other items such as 1” and 3/4” hydraulic hose and fittings are not listed but are also required
for proper installation. Those items must be obtained in the field.
• If desired an optional Thru-Wall Plate Kit can be ordered (p/n# 107362). It will assist in routing
the utilities from the bay to the equipment room.
Note: See the chart that follows for a list of needed parts.
➢ All these items below can be purchased through the Belanger® Aftermarket group, using the
referenced part numbers.
To Next Page
Loading...
