INSTALLATION AND STARTUP
1MANUL220 Belanger, Inc.® * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 22-19
Chapter 22 Initial Startup
Check the Remaining Outputs
4) Close both side pods covers and the manifold covers.
5) Press Fault Reset and the FreeStyler® should go to the HOME position (at the exit end of the
bay).
6) Verify that no Faults have occurred at the Fault screen of the HMI (E-1063 Human Machine
Interface).
7) Check for water leaks at each output.
Flush the lines and insert the nozzles per the diagram for those outputs.
See settings below:
8) Install all nozzles according to the Nozzle Chart in this document.
To Next Page
Loading...
