4/188
Bosch Rexroth AG, MIT: ActiveMover, 3 842 564 874/2021-04
7 Installation 50
7.1 Unpacking 50
7.2 Installation requirements 50
7.2.1 Installation position 50
7.3 Required tools 50
7.3.1 Mechanical system 50
7.3.2 Electrical system 50
7.4 Symbols used 51
7.5 Assembling the product 52
7.5.1 Assembly procedure 52
7.5.2 Customer base frames 54
7.5.3 Assembly without fi xing plates on customer base frames 54
7.5.4 Positioning and aligning the base frame 55
7.5.5 Assembling the section module on a base frame 57
7.5.6 Assembling the curve module on a base frame 64
7.5.7 Attaching and connecting system sections 66
7.5.8 Aligning section modules (rough adjustment) 71
7.5.9 Assembling the profi le connector for 2 section modules 74
7.5.10 Assembling the profi le connector for curve module and section module 75
7.5.11 Aligning the upper V-rail, section module to section module
(fi ne adjustment) 76
7.5.12 Aligning the upper V-rail, section module to curve module
(fi ne adjustment) 79
7.5.13 Assembling and aligning the guide rails 82
7.5.14 Mounting/removing workpiece pallets 83
7.5.15 Assembling, adjusting and connecting the IR reading head ID system 86
7.5.16 Assembling the power supply 88
7.6 Electrical connection of the product 89
7.6.1 Assembling the EMC cable glands and cable guard pipe 91
7.6.2 Inserting the connection cable 92
7.6.3 Inserting the power supply line into section/curve module 93
7.6.4 Connecting grounding and power cables (28 V)
(from left section/curve module) 94
7.6.5 Connecting grounding and power cables (28 V)
(from right section/curve module) 95
7.6.6 Connecting network and cable control voltage (24 V)
(from left section/curve module) 96
7.6.7 Connecting network and cable control voltage (24 V)
(from right section/curve module) 97
7.6.8 Connecting the network connections and power supplies in the
control panel 97
7.6.9 IR reading head ID system (optional) 98
7.6.10 Connecting network - printed circuit boards (gateway) 99
7.6.11 Network connection Left Network and Right Network 101
7.6.12 Connect power supply in section module 102
7.6.13 Connect power supply in curve module 103
7.6.14 Connect power supply in the control cabinet 104
7.6.15 Ethernet POWERLINK 105
7.6.16 Ethernet port (Windows PC) 106
To Next Page
Loading...
