6/188
Bosch Rexroth AG, MIT: ActiveMover, 3 842 564 874/2021-04
10.4.10 Replacing the V-guide rollers 138
10.4.11 Replacing the upper V-rail (section module) 139
10.4.12 Replacing the upper V-rail (curve module) 140
10.4.13 Replacing the guide rails (section module) 141
10.4.14 Replacing the cover of the coil (section and curve module) 142
10.4.15 Replacing the power supply 143
10.4.16 Replacing the printed circuit board (coil driver) (section module) 144
10.4.17 Replacing the printed circuit board (coil driver) (curve module) 146
10.4.18 Replacing the printed circuit board (gateway) (section module) 147
10.4.19 Replacing the printed circuit board (gateway) (curve module) 149
10.4.20 Replacing the drive thermistors 151
10.4.21 Replacing the section/curve module main fuse 152
10.4.22 Replacing the section/curve module coil fuse 153
10.4.23 Replacing the measuring system (encoder) (section module) 154
10.4.24 Replacing the measuring system (encoder) (curve module) 155
10.4.25 Replacing the ActiveMover power supply air fi lter 156
10.5 Adjustment and calibration 157
10.5.1 Checking and adjusting the measuring system distance 157
10.5.2 Primary and secondary measuring system 159
10.5.3 Encoder numbering and order 160
10.5.4 Assembling and aligning the calibration set (optional) 161
10.5.5 Checking position of the calibration set 167
10.5.6 Referencing the encoder position 169
10.5.7 Adjusting the primary measuring system 170
10.5.8 Adjusting the secondary measuring system 172
10.5.9 Installing/removing the WT mounting (optional) 175
11 Troubleshooting 176
11.1 Localizing and remedying short circuits 176
11.2 Communication error 178
11.3 Operating mode error 178
11.4 Diagnostic LEDs 179
11.4.1 ActiveMover controller 179
11.4.2 Printed circuit board (coil driver) 179
11.4.3 Printed circuit board (gateway) 180
12 Decommissioning 181
13 Disassembly and replacement 182
13.1 Preparing the product for storage/later use 182
14 Disposal 183
15 Upgrading and modifi cation 183
16 Technical data 184
16.1 Mechanical data 184
16.2 Electrical data 184
16.3 Dimensions and weight 184
16.4 IR ID system 186
16.5 Ambient conditions 186
17 Appendix 186
17.1 Trademark information 186
To Next Page
Loading...
