5-103
Confidential
(3)
Disconnect
the Connector from the LED power relay PCB ASSY.
Fig. 5-109
(4) Remove the Taptite cup S M3x6 SR screw, and then remove the LED FG harness from
the Main PCB shield plate.
Fig. 5-110
Note:
- After disconnecting the flat cable(s), check that each cable is not damaged at its end
or short-circuited.
- When connecting the flat cable(s), do not insert it at an angle. After insertion, check
that the cable is not at an angle.
LED power relay PCB ASSY
Connector
LED FG harness
Main PCB
(Taptite cup S M3x6 SR)
Main PCB shield plate
To Next Page
Loading...
