7-11
Confidential
<Operating procedure>
(1) Press the 1 and 0 buttons in this order in the initial state of the maintenance mode.
The machine displays “WSW00” on the LCD and becomes ready to accept a worker
switch number.
(2) Enter the desired number from the worker switch numbers (01 through 76).
The following appears on the LCD.
(3) Enter a value to be set (0 or 1) using the 0 and 1 buttons.
(4) Press the OK button. This operation saves the newly entered selector values onto the
EEPROM and readies the machine for accepting a worker switch number.
(5) Repeat steps (2) through (4) until the modification for the desired worker switches is completed.
(6) When the Stop/Exit button is pressed, the machine beeps for one second and returns to
the initial state of the maintenance mode.
WSW66 Reserved (Change of the setting is prohibited) App. 1-52
WSW67 Reserved (Change of the setting is prohibited) App. 1-52
WSW68 Reserved (Change of the setting is prohibited) App. 1-52
WSW69 Reserved (Change of the setting is prohibited) App. 1-52
WSW70 Reserved (Change of the setting is prohibited) App. 1-52
WSW71 Reserved (Change of the setting is prohibited) App. 1-52
WSW72 Reserved (Change of the setting is prohibited) App. 1-53
WSW73 Reserved (Change of the setting is prohibited) App. 1-53
WSW74 ADF stop control App. 1-53
WSW75 Paper feeding parameter for turning the document counter
when the machine takes action duplex scanning
App. 1-53
WSW76 The limited number of the documents in reverse for paper
ejection of the simplex scanning from ADF
App. 1-54
WSW77 The limited number of the documents in reverse for paper
ejection of the duplex scanning from ADF
App. 1-54
Memo:
- To cancel this operation and return to the machine to the initial state of the maintenance
mode during the above procedure, press the Stop/Exit button.
- If there is a pause of more than one minute after a single-digit number is entered for
double-digit worker switch numbers, the machine will automatically return to the initial
state of the maintenance mode.
WSW No. Function Refer to:
Selector 1 Selector 8