7-44
Confidential
1.4.23 Setting by country (Function code 74)
<Function>
This function allows you to customize the EEPROM according to language, function settings,
and worker switch settings.
<Operating procedure>
(1) Press the 7 and 4 buttons in this order in the initial state of the maintenance mode.
The present customizing code is displayed.
(2) Enter the desired customizing code (e.g., MFC-9320CW (USA): 0201). The newly
entered code appears.
To enter letters “A” through “F”, press the 1 through 6 buttons while holding down the #
button respectively.
(3) Press the OK button.
The machine saves the setting and displays the “PARAMETER INIT” on the LCD.
The machine beeps for one second and returns to the initial state of the maintenance
mode.
Note:
If you replace the main PCB, be sure to carry out this procedure.
Note:
The machine does not work properly when an incorrect code is entered.
Memo:
When the Stop/Exit button is pressed, or when no button is pressed for one second
procedure during the above procedure, the machine cancels the above, beeps for one
second and returns to the initial state of the maintenance mode.
In this case, the modified setting data is not saved.
To Next Page
Loading...
Need help?
General
