Brother MFC-9010CN - LED Head Control PCB ASSY

5-122
Confidential
8.50 LED Head Control PCB ASSY
(1) Remove the LED FFC cover film from the Sub frame ASSY.
Fig. 5-139
(2) Disconnect the four FFC sheet (CN1, CN2, CN3, CN4) of the LED ASSY from the LED
head control PCB ASSY.
Fig. 5-140
Note:
- After disconnecting the flat cable(s), check that each cable is not damaged at its end
or short-circuited.
- When connecting the flat cable(s), do not insert it at an angle. After insertion, check
that the cable is not at an angle.
Sub frame ASSY
LED FFC cover film
CN1CN2CN3CN4
(K) (Y) (M) (C)
LED head control PCB ASSY
Lock
Lock