3-8
Confidential
2.2 Error Messages
The error messages displayed on the LCD of the product and their description and measure
are shown in the table below.
* (X) at the end of the message shows the color of the toner cartridge or drum unit.
(X) must be either K (Black), Y (Yellow), M (Magenta) or C (Cyan).
Error message
Description/Measure
Refer to:
Access Error
(USB direct interface
model only)
The USB device was removed while data was
processing. Press Job Cancel button. Reinsert the
USB device and try to print with Direct Print or PictBridge.
3-48
Belt End Soon
The belt unit is near the end of its life. Buy a new belt
unit before you get a “Replace Belt” message.
3-27
Calibrate
Scroll message:
Calibration failed.
See
Troubleshooting
chapter in User's
guide.
- Turn off the machine. Wait a few seconds and turn it
on again.
- Put in a new drum unit.
- Put in a new belt unit.
- Put in a new waste toner box.
3-31
3-36
3-56
Cartridge Error
Take out the drum unit and toner cartridge assembly for
the toner color that is indicated on the LCD. Remove the
toner cartridge from the drum unit and install a new toner
cartridge in the drum unit. Put the drum unit and toner
cartridge assembly back into the machine again.
3-46
Cooling Down Wait
for a while
The temperature of the drum unit or toner cartridge is too
hot.
3-32
Comm. Error
Poor telephone line quality caused a communication error.
3-88
Connection Fail
You tried to poll a fax machine that is not in polled waiting
mode.
3-96
Cover is Open
Close the cover that is indicated on the LCD. 3-25
3-38
3-42
Disconnected
The other person or other person’s fax machine stopped
the call.
3-96
Document Jam
The document was not inserted, or fed properly. 3-42
3-101
DR Mode is Use
The machine is set to Distinctive Ring mode. 3-98
Drum End Soon
(X)
* or
Drums End Soon
The drum unit is near the end of its life. Buy a new toner
cartridge that is indicated on the LCD before you get a
“Replace Drum” message.
3-24
Drum Error
Clean the corona wires. If the LCD still shows the same
error message after you have cleaned the corona wire,
replace the drum unit with a new one that is indicated on
the LCD.
3-14
3-32
Fuser Error
Turn off the power switch, wait a few seconds and then
turn it on again. Leave the machine for 15 minutes with
the power on.
3-25
3-50
To Next Page
Loading...
Need help?
General
