Brother MFC-9010CN - Page 396

5-169
Confidential
(4) Release the two Hook A in the direction of the arrow 4a and remove the three Hook B in the
direction of the arrow 4b. Then, remove the Paper eject guide from the Lower air duct.
Fig. 5-213
Fig. 5-214
Assembling Note:
When assembling the Paper eject guide onto the Lower air duct, make sure to pass the
Eject rear harness ASSY through the “A” of the Lower air duct before assembling it.
Hook A
Lower air duct
Paper eject guide
Hook B
4b
4a
4c
Hook A
Lower air duct
“A”
Eject rear harness ASSY
Eject rear sensor
PCB ASSY