Brother MFC-9010CN - Page 411

5-184
Confidential
(5) Turn the Main body upside down.
(6) Remove the two Taptite bind B M4x12 screws to remove the Under bar from the Main body.
Fig. 5-237
(7) Disconnect the Connector (CN2) of the Heater 120V harness ASSY from the Low-voltage
power supply PCB ASSY.
Fig. 5-238
Taptite bind B M4x12
Main body
Under bar
<Bottom of main body>
Low-voltage power supply
Heater 120V harness ASSY
CN2
<Right side>
PCB ASSY