Danfoss VLT AutomationDrive FC 360

Setup: All setups Conversion index: –
Data type: Uint8 Change during operation: False
The drive provides higher current than normal current levels to enhance breakaway-torque capacity.
Option Name
[0] Off
[1] On
4-25 Power Limit Motor Factor Source
Default value: [0] No function Parameter type: Option
Setup: All setups Conversion index: –
Data type: Uint8 Change during operation: True
Set an analog input to scale the motoric power limit set in parameter 4-82 Power Limit Motor Mode from 0% to 100%.
Option Name
[0] No function
[2] Analog in 53
[4] Analog in 53 inv
[6] Analog in 54
[8] Analog in 54 inv
4-26 Power Limit Gener. Factor Source
Default value: [0] No function Parameter type: Option
Setup: All setups Conversion index: –
Data type: Uint8 Change during operation: True
Set an analog input to scale the generatoric power limit set in parameter 4-83 Power Limit Generator Mode from 0% to 100%.
Option Name
[0] No function
[2] Analog in 53
[4] Analog in 53 inv
[6] Analog in 54
[8] Analog in 54 inv
102 | Danfoss A/S © 2024.01 AU275649936274en-001401 / 130R0507
Programming Guide | VLT® AutomationDrive FC 360