Danfoss VLT AutomationDrive FC 360

4.15 Parameter Group 16-** Data Readouts
4.15.1 16-0* General Status
16-00 Control Word
Default value: 0 Parameter type: Range (0–65535)
Setup: 1 setup Conversion index: 0
Data type: Uint16 Change during operation: True
View the control word sent from the drive via the serial communication port in hex code.
16-01 Reference [Unit]
Default value: 0.000 ReferenceFeedbackUnit Parameter type: Range (-4999.000–4999.000
ReferenceFeedbackUnit)
Setup: 1 setup Conversion index: -3
Data type: Int32 Change during operation: True
View the present reference value applied on impulse or analog basis in the unit resulting from the configuration selected in parameter
1-00 Configuration Mode.
16-02 Reference [%]
Default value: 0.0% Parameter type: Range (-200.0–200.0%)
Setup: 1 setup Conversion index: -1
Data type: Int16 Change during operation: True
View the total reference. The total reference is the sum of digital, analog, preset, bus, and freeze references, plus catch up and slow down.
16-03 Status Word
Default value: 0 Parameter type: Range (0–65535)
Setup: 1 setup Conversion index: 0
Data type: Uint16 Change during operation: True
View the status word sent from the drive via the serial communication port in hex code.
16-05 Main Actual Value [%]
Default value: 0.00% Parameter type: Range (-200.00–200.00%)
Setup: 1 setup Conversion index: -2
Data type: Int16 Change during operation: True
View the 2 byte word sent with the status word to the bus master reporting the main actual value.
16-09 Custom Readout
Default value: 0.00 CustomReadoutUnit Parameter type: Range (0.00–9999.00
CustomReadoutUnit)
254 | Danfoss A/S © 2024.01 AU275649936274en-001401 / 130R0507
Programming Guide | VLT® AutomationDrive FC 360