Programming Guide | VLT® AutomationDrive FC 360
Enter the filter time constant. This is a first-order digital lowpass filter time constant for suppressing electrical noise in terminal X48/10. A
high time constant value improves dampening but also increases the time delay through the filter.
35-35 Term. X48/10 Temp. Monitor
Default value: [0] Disabled Parameter type: Option
Setup: All setups Conversion index: –
Data type: Uint8 Change during operation: True
This parameter gives the possibility of enabling or disabling the temperature monitor for terminal X48/10. The temperature limits can be
set in parameter 35-36 Term. X48/10 Low Temp. Limit/parameter 35-37 Term. X48/10 High Temp. Limit.
Option Name
[0] Disabled
[1] Enabled
35-36 Term. X48/10 Low Temp. Limit
Default value: -50 Parameter type: Range (-50–204)
Setup: All setups Conversion index: 0
Data type: Int16 Change during operation: True
Enter the minimum temperature reading that is expected for normal operation of the temperature sensor at terminal X48/10.
35-37 Term. X48/10 High Temp. Limit
Default value: 204 Parameter type: Range (-50–204)
Setup: All setups Conversion index: 0
Data type: Int16 Change during operation: True
Enter the maximum temperature reading that is expected for normal operation of the temperature sensor at terminal X48/10.
4.25 Parameter Group 37-** Application Settings
4.25.1 37-0* Application Mode
37-00 Application Mode
Default value: [0] Drive mode Parameter type: Option
Setup: All setups Conversion index: –
Data type: Uint8 Change during operation: False
Set the application mode.
Danfoss A/S © 2024.01 AU275649936274en-001401 / 130R0507 | 297
To Next Page
Loading...
Need help?
General