Danfoss VLT AutomationDrive FC 360

Data type: Int16 Change during operation: True
View an extra description of the error. This parameter is mostly used with alarm 38, Internal Fault.
15-32 Alarm Log: Time
Default value: 0 s Parameter type: Range (0–2147483647 s), Array
[10]
Setup: All setups Conversion index: 0
Data type: Uint32 Change during operation: False
View the time when the logged event occurred. Time is measured in seconds from drive start-up.
4.14.3 15-4* Drive Identification
Parameters containing read-only information about the hardware and software configuration of the drive.
15-40 FC Type
Default value: 0 Parameter type: Range (0–7)
Setup: 1 setup Conversion index: 0
Data type: VisStr Change during operation: False
View the drive type. The readout is identical to the power field of the type code definition, characters 1–6.
15-41 Power Section
Default value: 0 Parameter type: Range (0–20)
Setup: 1 setup Conversion index: 0
Data type: VisStr Change during operation: False
View the power size of the drive. The readout is identical to the power field of the type code definition, characters 7–10.
15-42 Voltage
Default value: 0 Parameter type: Range (0–20)
Setup: 1 setup Conversion index: 0
Data type: VisStr Change during operation: False
View the mains voltage of the drive. The readout is identical to the power field type of the type code definition, characters 11–12.
15-43 Software Version
Default value: 0 Parameter type: Range (0–20)
Setup: 1 setup Conversion index: 0
Data type: VisStr Change during operation: False
View the combined software version (or package version) consisting of power software and control software.
250 | Danfoss A/S © 2024.01 AU275649936274en-001401 / 130R0507
Programming Guide | VLT® AutomationDrive FC 360