Danfoss VLT AutomationDrive FC 360 Programming Guide

Programming Guide | VLT® AutomationDrive FC 360
1 Introduction
1.1 Purpose of this Programming Guide
This programming guide provides information on working with parameters on the VLT® AutomationDrive FC 360.
It provides information on how to program the drive, and a list and description of all parameters.
VLT® is a registered trademark for Danfoss A/S.
1.2 Additional Resources
Other resources are available to understand advanced drive functions and programming.
l The operating guide provides basic information on mechanical dimensions, installation, and programming.
l The design guide provides information on how to design motor control systems.
Supplementary publications and manuals are available from the Danfoss website.
1.3 Document and Software Version
This guide is regularly reviewed and updated. All suggestions for improvement are welcome.
The original language of this manual is English.
Table 1: Document and Software Version
Edition Remarks Software version
AU275649936274, version 1401 Update for J1–J9 enclosure sizes of the
drive.
4.20
1.4 Approvals and Certifications
Danfoss A/S © 2024.01 AU275649936274en-001401 / 130R0507 | 9

Danfoss VLT AutomationDrive FC 360 Specifications

General

Category	DC Drives
Output Voltage	0 to Input Voltage
Control Method	V/f, Vector Control
Communication Protocols	Modbus RTU
Enclosure Rating	IP20
Brake chopper	Built-in
EMC	Compliant with EN 61800-3
Protection Features	Overcurrent, overvoltage, undervoltage, short circuit, overtemperature
Ambient Temperature	-10 to +50 °C
Storage Temperature	-25 to +70 °C
Relative Humidity	5 - 95% non-condensing
Altitude	Up to 1000 m
Input Voltage	380 to 480 V