Figure 4: Grounding of Shielded/Armored Control Cables
1.5.2 Start/Stop
NOTICE
Make sure the drive is under the factory setting before doing the following operation.
Terminal 18 = Parameter 5-10 Terminal 18 Digital Input[8] Start.
Terminal 27 = Parameter 5-12 Terminal 27 Digital Input[0] No operation (default coast inverse).
12 | Danfoss A/S © 2024.01 AU275649936274en-001401 / 130R0507
Programming Guide | VLT® AutomationDrive FC 360
To Next Page
Loading...
